Compass ST-1500 Sliding Table: Compatibility Information

Created by Gabriel Izzo, Modified on Mon, 18 May at 8:20 PM by Gabriel Izzo

Compass ST-1500 Sliding Table · Compatibility

Compass ST-1500 Sliding Table — Compatibility Information

The Compass ST-1500 Sliding Table comes with pre-drilled holes designed to be compatible with the models shown in the diagram below, allowing for convenient mounting. This is not an exhaustive list — other machines or hole patterns may also be compatible.

Compatible Models Diagram

ST-1500 Pre-Drilled Hole Pattern — Compatible Models

ST-1500 compatibility diagram showing pre-drilled hole patterns for compatible machines

Equipment Not on the Compatibility List?

If your equipment does not have pre-existing holes that align with the ST-1500's mounting pattern, you have two primary options:

Modify the ST-1500

Widen the existing holes or drill new through-holes in the sliding table to match the hole pattern of your equipment.

Modify the Equipment

Drill and tap new threaded holes in the mounting surface — such as the left wing, main table, or other appropriate areas — to match the ST-1500's existing hole pattern.

Critical Height Requirement

Sliding table surface must be 0.010" to 0.020" higher than the machine surface

When mounting the Compass ST-1500, the sliding table surface must be positioned 0.010" to 0.020" higher than the surface of the machine it is being installed on. This slight height difference ensures proper clearance for workpieces and allows the crosscut fence to glide smoothly over the stationary table surface without friction.

Instruction Manual

PDF Compass ST-1500 Sliding Table Instruction Manual ↗

Need help with alignment or mounting procedures? Please contact our support team.