How to get the blade perfectly square and set up with the keel/how to properly adjust and set up the keel? : Harvey Industries International, Inc.

How to get the blade perfectly square and set up with the keel/how to properly adjust and set up the keel? Print

Created by: Samantha V.

Modified on: Thu, 10 Nov, 2022 at 1:49 PM

(Reference) Page 12 Section 5 of manual for instructions.

Set the trunnion at 90* degree and check to ensure squared with table
Have to loosen the keel (4 screws) to move the keel assembly left/right to center it with the slots.
Use a machinist scale or “Allen” key/card to check “parallelism”
Once setup, tighten all screws and adjust angle indicate piece (at front trunnion block)

Samantha is the author of this solution article.

Did you find it helpful? Yes No

Help Desk Software by Freshdesk Support Desk